Capabilities
CNC routing for plastic sheet.
If the part starts as flat plastic and you have a drawing, a sample or a sketch, we can quote it — one prototype or a full production run.
CNC routing & cutting
Profiles, pockets, hole patterns, slots and cutouts routed from sheet with repeatable accuracy part after part.
Drilling & countersinking
Fastener holes, countersinks and through-holes placed by the program, not by hand.
Edge finishing
Deburred, eased or rounded edges so parts are safe to handle in the field.
Engraving & marking
Part numbers, drawing numbers and orientation arrows cut right into the part.
Drawing from a sample
Send a photo or the part itself — we draw it, you approve it, we cut it.
Kitting & palletizing
Parts counted, bundled by run or phase, and shipped ready for the crew.
Materials we cut
Engineering plastics, ready to route.
| Material | Known for | Common parts |
|---|---|---|
| HDPE | Tough, non-conductive, moisture and chemical resistant | Duct bank spacers, separator plates, trench cards |
| Reprocessed HDPE | Lower-cost HDPE for buried, non-cosmetic use | High-volume spacer runs |
| PVC | Rigid, flat, flame-retardant grades | Spacers, panels, covers |
| Polypropylene | Light and chemically resistant | Spacers, tank parts, liners |
| UHMW | Very low friction, wear resistant | Wear strips, guides, skids |
| Acetal (Delrin) | Stiff, stable, machines cleanly | Precision brackets, standoffs |
| Polycarbonate | Clear and nearly unbreakable | Guards, covers, windows |
| ABS | Easy to fabricate, good impact strength | Enclosure parts, panels |
Not on the list? Ask — we source most plastic sheet on request.
Files we take
Whatever is on your desk.
DXF, DWG, STEP, IGES or PDF drawings. A hand sketch with dimensions. A phone photo of the old part next to a tape measure. We will turn it into a cut file and send it back for your OK.
- Prototype1 part to prove the fit
- Short runDozens to hundreds
- ProductionFull project quantities
- BlanketScheduled releases by phase